Walls and Ceiling-3
Filed under How To Videos
Video
How to Mark the Location for a Picture Hanger
Determining where to mark the location of a picture hanger on a wall can be a bit of a challenge. Don’t make the same mistake ever again. Watch this video for an easy tip on how to find the height to attach a picture hanger on a wall in your home.
Installing Crown Molding in a Room
Crown molding is a great way to add character to a room. Start by measuring each wall at the ceiling level. next, position crown molding right side up on the miter saw at the same angle it will be on the wall. Cutting crown molding to the correct angle and length can be a bit tricky, so watch this video to find out how it’s done.
How to Remove a Load Bearing Wall
Removing a load bearing wall in your home is not considered a DIY project, since it can result in injury and structural damage if not done correctly. When removing a load bearing wall, the load must be supported temporarily while the wall is removed and a beam strong enough to carry the load is put in place.
How to Paint a Frame Border on a Wall Using Painter’s Tape
To create a decorative frame border design on a wall, apply an outline of painter’s tape to the wall, then paint around the tape and remove it while still wet. This technique can be used to add visual accents to the wall as well. Watch this video to see how it’s done.
| Previous | 3 | 4 | 5 | Next |
Comments
3 Responses to “Walls and Ceiling-3”Trackbacks
Check out what others are saying about this post...[...] Previous [...]
[...] 3 [...]
[...] Until the middle of the 1800′s, most molding in America was made on the building site by carpenters. Most molding in America was made on the building site by carpenters who used hand planes, chisels and gouges. Imagine a time when everything was still make by hand. [...]