Tools and Hardware-3

Video

How to Remove Headless Nails

Watch this video to find out how to remove headless nails easily without damaging the wood using locking pliers and a hammer or pry bar. Start by placing a block of wood next to the nail to provide leverage for the hammer and protect the board. Next, position a pry bar or hammer around the nail.

How to Make an Extension Cord Carrier from a Bucket

To turn a 5-gallon bucket into a handy storage and carrying container for an extension cord, drill a hole in the side of the bucket near the bottom. Run the male end of the plug through the hole from inside the bucket and put the rest of the cord in the bucket for easy carrying. Watch this video to find out more.

How to Make a Drilling Jig for Cabinet Handles and Knobs

When installing cabinet handles on doors and drawers, the screw holes need to be drilled identically, so the hardware will align properly. Find out how to make a simple jig from a scrap of plywood with attached strips to act as stops. Watch this video to find out more.

How to Make a Crosscut Guide for a Circular Saw

The best way to make square, straight crosscuts on lumber or plywood with a circular saw is by using a homemade crosscut guide. Check out this clip to find out how to make a simple crosscut guide for your circular saw like a certified pro.

Previous

3

4

5

Next